Overview and requirements
The Android device can be secured in the vehicle using an active bracket, which also charges the device at the same time. The active bracket is attached to the dashboard using a console, e.g. from KUDA.
Requirements:
- The active bracket must be connected to a continuous power supply.
- We recommend using the SPEDION cable loom for the connection.
CAUTION – Loss of warranty
The active bracket must be protected by a separate 3A fuse to avoid voiding the warranty!
Use the plug supplied to connect to the SPEDION cable loom; a fuse is fitted there.
Alternatively, you can fit a separate 3A fuse on site if you are unable to tap into the voltage at the SPEDION cable loom.
If you have any questions, please contact SPEDION support:
Phone: +49 (0) 6024 50990-199
E-mail: support@spedion.de
Install bracket
- Attach the console (e.g. KUDA or Arat) to the appropriate location for your vehicle type.
For further information on installation, please contact your vehicle manufacturer or SPEDION support. - Attach the Brodit active bracket to the console.
- Run the cable from the Brodit active bracket to the SPEDION cable loom.
- Connect the supplied white plug to the red and black cables on the Brodit active bracket.
Connection instructions
- You can identify the end for the black cable (ground) by a mark on the white plug.
- Please note that the white plug can only be connected to the SPEDION cable loom in one direction, and connect the red and black cables as shown in the diagrams below!
- Connect the white plug on the Brodit active bracket to the white plug on the SPEDION cable loom.
- Check that the LED light on the Molex box is green.
- Secure the Android device in the Brodit active bracket.